Service area
Security systems in Brisbane
Brisbane's housing stock is unusually varied for an Australian capital, and it genuinely changes how a security system goes in. A timber Queenslander on stumps, a 1970s lowset brick home and a new render-and-cladding build each present completely different cabling routes, mounting surfaces and roof access. A quote that doesn't account for which one you have is a quote that's going to move.
Queenslanders and character housing
Elevated timber homes give you an underfloor space that often makes cable runs easier than in a slab-on-ground house. What they don't give you is easy external mounting — weatherboard and chamferboard need appropriate fixings, and VJ walls inside can make internal runs awkward. Character-protected properties also limit what can be visibly attached to a street-facing facade, which affects camera placement before anything else does.
Post-war lowset brick and tile
The most common suburban stock across Brisbane's middle ring. Tiled roofs with reasonable cavity access usually make runs straightforward, though older tile is brittle and needs care. Brick means masonry fixings and thought about where penetrations go, because you can't easily move them later.
Storm season is a design input
Summer storms across the south-east are hard on outdoor equipment and on power. Surge protection on the recorder and network gear, sensible cable entry that doesn't channel water inside, and battery backup that actually carries the system through an outage rather than beeping through it. A system that drops out every time the power blinks stops being trusted.
Small commercial across the inner suburbs
A lot of Brisbane's small commercial sits in converted or shared buildings — a shop in a strip, a studio in an old warehouse, an office above retail. These usually come with landlord restrictions on penetrations and reinstatement, and shared building infrastructure you don't control. Establishing that early is the difference between a smooth job and an awkward conversation with a building manager.
What we install in Brisbane
CCTV installation
Read moreAccess control
Read moreAlarm systems
Read moreIntercoms
Read moreNetwork installation
Read moreCommercial security
Read moreRegularly working across Chermside, Carindale, Mount Gravatt, Indooroopilly, Aspley, Wynnum, Sunnybank and Everton Park, and the surrounding Brisbane area.
What you get on every job
Labelled cabling
Cables are identified, so the next person to open the cabinet — whether that's us in three years or someone else entirely — can tell what goes where without tracing every run by hand. It costs a few minutes during the install and saves hours later.
A camera position and coverage plan
A site plan showing where each camera sits and what it covers, agreed before anything is installed. It's how the design conversation happens — you can see what you're getting and move a camera on paper rather than after it's on the wall. It stays useful afterwards as a record of what was agreed.
Your credentials, in writing
Admin passwords, app logins and account ownership are yours and are handed over documented. This shouldn't be worth mentioning, but installers withholding credentials to protect their service work is common enough that it's worth being explicit: it's your system, and you'll be able to administer it or hand it to someone else.
A commissioning test record
A record of what was tested and the result — night footage actually reviewed, detectors walk-tested, remote access checked from outside your network. It comes from commissioning industrial plant, where nothing is considered finished until it's been proven under the conditions it has to work in. The same principle applies to a system whose whole job is to work at 2am.
Questions about Brisbane
Do you cover all of Brisbane?
Yes — north and south side, from the inner suburbs out to the city fringes. If a job sits outside a sensible travel distance it's better to say so than to take it and be slow to return for service.
Can you install without damaging a character home?
That's the usual requirement on older Brisbane homes, and it drives where cameras can go. Underfloor and roof-cavity routes usually avoid visible external cabling, and mounting points get chosen with the facade in mind.
Do you work on apartments and units?
Within what the body corporate permits, which is often less than owners expect. Anything touching common property or the building's exterior generally needs approval, so that gets checked before the job rather than during it.
Working in Brisbane?
Tell me about the site and what you’re trying to protect.